FE250

What is the price?

Door Holder, Floor Mounting, 400N, with Release Button

Low power - 1.6 W
400 N holding force
Anti-remnant ejector
Spark suppression diode and reverse polarity protection
Release button

View all

Related products

FE225-150

Bracket Lenght: 150mm • Release button: No • 150 mm

FE225-300

Bracket Lenght: 300mm • Release button: No • 300 mm

FE527

Angle: Standard • Release button: No • 55 x 18 mm (Ø x D)

FE529

Angle: 120° • Release button: No • 55 x 50 mm (Ø x D)

FE260-325

Tube length: 325 mm • Holding force N (Newton): 400 • Release button: Yes • 80 x 90 x 300 mm (W x H x D) 90° setup, 80 x 90 x 325 mm (W x H x D) 180° setup

N-MC-BB-G

MCP • Addressable, Conventional • AS Series • Accessory, Single-action • Noryl SE100 (self-extinguishing)

NC-MC-0-G

MCP • Conventional • Single-action • Flame retardent ABS

KE-DP3120W-SN

Notification, Smoke • Addressable • Excellence • Isolator, Point optical, Sounder • PC / ABS

At a glance

General

The FE250 is a floor mount door holder, in a Bayblend housing, which offers a 400N holding force and a release button. Cable entry is possible from the back or from the sides, and the release button can be located at the bottom, or one of the sides. The metal mounting bracket offers two mounting options: inside – anti-vandal mode & standard (as shown).

Magnet construction

The magnet is constructed with a pressed coil and anti-remenance pin, giving it a protection of IP54. The protection diodes are integrated into this construction.

Housing

The plastic housing is manufactured from Bayblend and contains 30% PA6 glass fiber, which makes it much stronger than standard ABS. Bayblend offers high heat resistance, high impact and notched impact strength, and high stiffness and dimensional stability.

Installer friendly

- For practical ease of installation, the door holder comes complete with electrical screw terminals.
- The housing is predrilled in a practical, standard format for rapid mounting.
- The door holder is supplied complete with a keeper plate, which offer angular adjustment.
- The release button can be position in three different locations: bottom, left or right
- Cable entry can be done in four different locations: back, top, left or right.
- The door holder can be mounted “inside” of metal bracket – anti-vandal mode, or standard/outside.

Approvals

The FE250 is fully approved according to EN1155.

Details

Low power - 1.6 W
400 N holding force
Anti-remnant ejector
Spark suppression diode and reverse polarity protection

Release button
EN1155 approved
Metal mounting bracket
Keeper plate included

Technical specifications

General
Holding force N (Newton)	400
Release button	Yes
Spark supression diode	Yes
Reverse polarity protection	Yes

Electrical
Power supply type	24 VDC
Power consumption	1.6 W
Duty cycle	100%

Physical
Physical dimensions	128 x 95 x 91 mm (H x W x D)

Environmental
IP rating	IP54 (magnet) IP42 (connection)

Regulatory
Standards	EN1155

Downloads

All downloads

Datasheet
Other EU certificate
CPD / CPR
Certificates

If available, the downloads of the Certificates, Software & Firmware and Media are displayed in their default language.